Roofing SWMS
Roof tiling, sheeting, restoration, gutters, and height safety
Roofing Complete Pack
8 documents — everything you need for roofing compliance.
Not sure your current documents are compliant? Run the free WHS compliance check →
Roofing work is classified as high-risk construction work under WHS Regulations s.291(a) due to the inherent risk of falls from 2 metres or more. A SWMS is mandatory for all roofing operations on construction sites.
Our roofing SWMS pack covers 8 activities including roof tiling, metal roof sheeting, roof restoration, gutter and fascia installation, skylights, and height safety system installation. Each document addresses the critical hazards of roofing work including falls from roof edges, falls through fragile roof surfaces, falling objects, heat stress, and adverse weather conditions.
Key Hazards Covered
- Falls from roof edges and eaves
- Falls through fragile roof surfaces (skylights, sheeting)
- Falling objects and tools from roof level
- Heat stress from prolonged sun exposure
- Manual handling of heavy roofing materials at height
- Adverse weather conditions (wind, rain, lightning)
Relevant Australian Standards
- AS/NZS 1891.1 Fall-arrest systems and harnesses
- AS/NZS 4994.1 Temporary edge protection
- AS 1562 Design and installation of sheet roof and wall cladding
- AS/NZS 4576 Guidelines for scaffolding safety
Individual Documents — $67.96 each
Roofing SWMS — Common Questions
Do I need a SWMS for roofing work?
Yes. Roofing work involves working at heights of 2 metres or more, which is specifically classified as high-risk construction work under WHS Regulations s.291(a). A SWMS must be prepared before any roofing work commences.
What fall protection is required for roofing?
Our roofing SWMS documents specify a hierarchy of fall protection controls: edge protection systems (AS/NZS 4994.1), safety mesh, full body harnesses with lanyards (AS/NZS 1891.1), and administrative controls including exclusion zones below.
Are roof restoration and re-roofing covered?
Yes. Our pack includes dedicated SWMS for roof restoration covering asbestos identification (pre-1990 roofs), old material removal, surface preparation, coating application, and working on fragile deteriorated surfaces.
Do I need a SWMS for roofing work in Victoria?
Victoria is not part of the national WHS scheme; it operates under the Occupational Health and Safety Act 2004 (Vic) and the OHS Regulations 2017 (Vic). Roofing work involving a risk of a fall of more than 2 metres is high risk construction work that requires a SWMS-equivalent statement under the OHS Regulations 2017 (Vic), so our roofing documents must cite Victorian law rather than the model WHS Regulations.
Do I need a SWMS for a small residential re-roof?
Yes, if any part of the work carries a risk of a fall of more than 2 metres, such as working at a single-storey roof edge or eaves. The size of the job does not matter; it is the fall risk that makes it high risk construction work under WHS Regulations s.291(a), so a SWMS is required before the work starts under s.299.
What roofing activities trigger a SWMS under s.291?
For roofing, the main trigger is the risk of a fall of more than 2 metres under WHS Regulations s.291(a), which can cover roof tiling, sheeting, restoration, gutter work and skylight installation at height. Other triggers can apply on the same job, such as disturbing asbestos on older roofs under s.291(d) or working near energised electrical installations under s.291(k).
Last updated: March 2026